Removing eth3 from bond0
root@linux:~ # ifenslave -d bond0 eth3
root@linux:~ # cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.4.0-2 (October 7, 2008)Bonding Mode: load balancing (round-robin)
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0Slave Interface: eth1
MII Status: up
Speed: 2500 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: d8:d3:85:e7:d1:70Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: d8:d3:85:e7:51:8a
Adding eth3 to bond1
root@linux:~ # ifenslave bond1 eth3
root@linux:~ # cat /proc/net/bonding/bond1
Ethernet Channel Bonding Driver: v3.4.0-2 (October 7, 2008)Bonding Mode: load balancing (round-robin)
MII Status: up
MII Polling Interval (ms): 0
Up Delay (ms): 0
Down Delay (ms): 0Slave Interface: eth0
MII Status: up
Speed: 2500 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: d8:d3:85:e7:d1:6cSlave Interface: eth3
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: d8:d3:85:e7:51:8b